|
aqui lo tienes en Ingles............It connects the receiver to the IHUB to directly connect it to the port series in the back part of the receiver. It can connect the fixed IHUB through cable when router and the modem or can be connected to router wireless and to change the way of wireless router of support to the reception to the receiver and to use a short cable to connect with the IHUB as it is above. The lights of the IHUB would have to ignite if the cable of connection with router is correct. These lights to verify the connection, as well as the data transmission. Software To unload the suitable software that corresponds to its receiver. You cannot use the device in other machines that the units of software especially is designed stops. He decompresses the file after unloading and copying the file in your memory USB. He remembers that he must correctly release the unit from the PC of Windows and before disconnecting the unit from the computer. He abra the menu and he goes to his menu of PVR. He selects the corresponding connector that connects unit USB in. The file must appear in the screen as it is next. It beats To accept and to allow that the receiver to load the file. It does not touch anything and it leaves is reinitiated when the receiver asks to him. The install program The receiver will be reinitiated and is probable that the resolution of the screen will be in the incorrect position. It presses yellow, then button shoots with an arrow upwards, soon to the left. That it must correct the color, but is not repeated to correct to NTSC. The IHUB must be connected and the connected cable. It will see a brief message that the module is connected. If it does not appear next, it deactivates the square with the remote control and to ignite it again. In the installation menu, IPCONFIG must appear in the part inferior. Abrir this configuration and to establish the following as one is. Configuration of DHCP = Type USE DNS. Adjustment to YES. Use of dominion = svftaiks.com Servant port = 1920 The serial number in the groove enters and asegúrese of which the numbers are correct. It would have exactly to be as one is in the device. It clicks in Applying. You must be able to go on approval by a channel that is not normally available and to see if it works. Also he can go to the Options of user. In the part inferior iks, Card of less, or both things can be selected. If the channel works in iks but not in its less functional card. Obvious ***** also with success guarantee. When the things are safe of their right to establish two. Solution of problems If you are reading this, then you are not safe if she is working or he is sure that she does not work. He verifies in the Web site that the service is being executed first. Asegúrese of which all the connections are correct and has lights in center and menu IPCONFIG in the installation menu can be seen. If the IHUB is not connected or restores, the menu element will not appear. If the IHUB restores, the system is due to reinitiate to work again. To confirm what its system of intellectual property and is its door of connection IP of router. Anyone of the computers in the system of leaching or a user like its IHUB is not due to confuse. Many routers include a program of Network of the Magic. It is not going to see the IHUB. Once you know and can identify the directions IP that are used in his system and that, asegúrese of which the door of connection IP is the same for the IHUB like the Vestibule of the IHUB. In some cases, the IHUB to incorrectly identify the access door and the incorrect use direction IP. This creates pasante incorrect direction IP for the device. If it finds that this it is the then case of changing the static DHCP and to correct the numbers of connection door and to assign an IP manually to the IHUB. The Local Council of the intellectual property is number IP IHUB. They turn it into a number over the last one of directions IP in use in its system Local port is the port of its receiver uses so that the 80. Subred is 255.255.255.0 At the moment to say that no. To change the IP of the servant to 77.93.75.115 DNS IP can show all the zero and that is well. The port of the servant is of 1920 and will continue being the same. Asegúrese of which now its serial number is correct and clicks in applying. You must verify and make sure that now the things are working. He wishes if it, he can verify the configuration remain in his place. If everything is well changing the DNS for use Yes. Now SVFTAIKS.COM like the dominion name will enter. It clicks in Applying and it tries again. In case the works to enter the establishment and the type of change of DHCP again. It clicks in Applying and all must correctly be functional For that they have a Motorola modem his possible one that router it can enter conflict with her. In this example one is over the client to buy to router TRENDnet that requires the period of investigation that to change the numbers to 7 of 10. If you have had problems with router in the past, this can now be the question to its salary and. To move router to the serial numbers to improve the best compatibility. In this case, the original footbridge 192.168.10.1 used by router that in conflict with the modem. One has changed to 192.168.7.1 like the footbridge and router and the worked modem well together. This change was the cause of its problem of why the IHUB would not work the device cannot detect the right of intellectual property correctly information. The IHUB of work once one easily adapts to the adjustments manuals, automatic
|