Ok folks here is the conversion for the ariza 700 to pansat 2700...

[loosegoose]

could someone please post a picture of the jtag connection on the board. The only thing I see is a 20 pin plug receptacle near the front of the machine and the pins are numbered as follows
19 17 15 13 11 9 7 5 3 1
20 18 16 14 12 10 8 6 4 2 so I tried the connection like this

5 X 13 5 4 3 2 X X X
X X X X X X X X X X it did nothing at all in "the wall"

in the file it shows

5 X 13 5 4 3 2 X X [] what the heck does this mean []?
X X X X X X X X X X

I even tried grounding the [] and still nothing.

[mississaugan]

where do I get a jtag?

[pchop6t9]

will the conversion work for the ariza 800??

[geforce82]

Originally Posted by loosegoose

could someone please post a picture of the jtag connection on the board. The only thing I see is a 20 pin plug receptacle near the front of the machine and the pins are numbered as follows
19 17 15 13 11 9 7 5 3 1
20 18 16 14 12 10 8 6 4 2 so I tried the connection like this

5 X 13 5 4 3 2 X X X
X X X X X X X X X X it did nothing at all in "the wall"

in the file it shows

5 X 13 5 4 3 2 X X [] what the heck does this mean []?
X X X X X X X X X X

I even tried grounding the [] and still nothing.

[] means gnd
18-25

[Zttt]

Dor those who have it working do i need a pansat 2700 remote

[pchop6t9]

no it works with the ariza remote

[pchop6t9]

anyone try this on the 800?? would it work??

[SenatorS]

...........front.............
x x x x x x x x x x
x x x x 2 3 4 13 x 5

were would ground be

[charly101]

Originally Posted by just_angel

slide the top off your ariza and look for this

Pin layout:
5 X 13 4 3 2 X X X []
X X X X X X X X X X

thats where you jtag

is this view from the front of the receiver or the back because some might hook up backwards

[geforce82]

Originally Posted by SenatorS

...........front.............
x x x x x x x x x x
x x x x 2 3 4 13 x 5

were would ground be

x x x x x x x x x [gnd]
x x x x 2 3 4 13 x 5

ground (18 - 25) on db25 cable and 20 on ariza


25 pin -2 via 100 ohm resistor to jtag -9
-3 via 100 ohm resistor to -11
-4 via 100 ohm resistor to -13
-5 via 100 ohm resistor to -19
-13 via 100 ohm resistor to -15
Pins 18 to 25 were connected together with a bare wire and connected to jtag pin 20 for the ground connection