Legacy quad setting

[mokezu]

Hi, guys.replaced DPP lnb with legacy quad today.want 2 use 4x1 disc.switch to connect 1 stb(kbox) for 119/110,97w , and second stb(pansat 2700) just for 119/110.got legacy quad(was cheap on ebay) and should get 119/110 for dish 500 for 4 stbs, and i can't for even 2.in order to get both 119/110 on kbox i have to use setting :119-legacy quad LNB1 port1, and for 110-legacy quad LNB2- port 2.also put (DTV dish-on port3,no problem, and finally 97w from inter.dish on port 4 disc.switch(also working fine).
at same time pansat lost signal completly(only see standard lnb type).
Please,help with legacy quad setting for both stbs for 119/110
thx.mokezu

please go back and read rule#1 thanks

[panek75]

If you want to get 110w/119w with your additional sat's thru the 4x1 diseqc switch on the kbox you will need to run two cables from the legacy quad to your switch not one.When running thru the diseqc you will just use the standard setting with a frequency of 11250 and set you diseqc ports accordingly.Since you won't be using a diseqc switch for the pansat you can run just one cable from any of the remaining ports on the quad to your receiver and try using these settings.

119w
lnb type:standard
lnb freq-11250
tp freq-12239
diseqc-none
legacy sw-sw42 dish #1 or quad lnb #1

110w
lnb type-standard
lnb freq-11250
tp freq-12224
diseqc-none
legacy sw-sw42 dish #2 or quad lnb #2

Note:I know lot's of folks use the dn legacy lnb's without issues but i personally am not a fan of them as they due tend to latch on to one port and not switch during channels changes.

[mokezu]

thanks panek75 for replay/now i got 2 cables from quad lnb to disq.switch,(1 for kbox,1 for pansat for 119/110).are you saying to put another cable(or jumper) from 3 or 4 port from quad lnb back to 4x1 switch.thx.mokezu
P.S. Sorry mods about "rule#1"/won't happend ,again

[olympusom]

mokezu ..check out the sticky
Switch Connection diagrams, what you need, how to connect.

[panek75]

If your going to be running diseqc switches to both units then yes you will need (2) cables from the legacy quad to each switch.If your not going to be running more then 110w/119 on the pansat then there is no need for the diseqc as you can run just one cable from the legacy quad to your receiver.