need some info

[everett c]

i guys ' i have a RCA DRD430RG that was converted to used a atmega card but is now damage. can some help me fine a vid mob to convert a RCA TO USE A ATMEGA CARD . thank in advance

[lutz diagram]

There was no vidmod for rca,it was all done with the flashburner program.
You run flashburner to unlock the flash chip,exit,and run jkeys to erase/ program.
Save the flash dump from the dead receiver and use that on the new one.

[everett c]

thanks for the info ,the only thing i don't no is where to connect the jtag cable
there is no pin on the board so this is where i am stuck

[seekr]

the vidmod for fta on 430 is to cut the trace from pin 2
of the processor and tie it high after the cut. it is
not strictly necessary, but it makes it easier to flash.
if you look for the how to for this, it will show you where
to hook the jtag. there is no atmega fix.

[naggie]

atmega fix are available

[naggie]

look into the receiver 1-10 it is there where the jtag must be connected

[naggie]

lugz diagram which file must be used when you are changing 430 to 301.13 dishnetwork receiver

[naggie]

where can i find the files

[lutz diagram]

Originally Posted by naggie

lugz diagram which file must be used when you are changing 430 to 301.13 dishnetwork receiver

I guess the one poster #1 has in his dead receiver.