k-box down

[mikaelawiggs]

im up and running all i did is options turned off tp auto update save it my khub went red then back green so i went back and turn tp auto update back on and saved. Im up and running !

[aid]

Did it go down? Not sure from the reports LMFAO

[mikaelawiggs]

menu
options
auto/tp update....turn off and save and exit out
khub goes red then back green
go back
menu
options
auto/tp update ....turn back on and save and exit
you have picture!!!!!

It worked for me been up for 10Min so far no problems yet.

[nada233]

do a reboot from back and it will come back

[yankeepride]

still up in norcali comcast

[dssduck]

I'm still down for the first time since 2.12 was released. Made it through the last outage with no problem turned on my TV at about 3:15 pm pst and nada first got the ethernet not connected notice and rebooted now its the connecting please wait notice and checkng please wait in config/net settings - tried rebooting a few times no go. I'm going to just wait for abit and if rebooting doesn't work then I'll try loading 2.14 and see if that does any good.

PRODIGY W/V2 KHUB
TELNOR DSL
2.12

[zahoor1]

Reboot ur reciever or ur modem.

[tvinoff46]

finally up here in northern california, reboot switch back then came back on

[dssduck]

Had already tried rebooting numerious times - when a kbox/khub reboot doesn't work I automatically reboot my router/modem and the kbox/khub. This time it didn't work so decided to upgrade from 2.12 to 2.14.

After loading 2.14 and rebooting box, hub and router/modem first thing I got was khub not connected - wam bam thank you mam that probably meant I had a hot glue failure*.

I powered off the kbox/khub front and back and removed khub from the kbox (there goes my hot glue effort* to keep it connected) then unplugged the ethernet cable from the khub and plugged it back in and then plugged the khub back into the kbox and jiggled it around abit for good luck (quack) and powered back up. Took a couple of moments with the checking please wait notice but then I got the module connection ok message and TV is back up!

*I've had a connectivity issue with my Kbox and v2 Khub since I took it out of he box at the beginning of August. Was going down all the time with the red light comming on the Khub and module not connected notice. I would jiggle it around or repeatedly remove it and plug it back in and EVENTUALLY it would connect and I would be up again - so I finally decided to try a remedy on my own (bad hardware design it should have had 2 screws to secure it in place with the kbox). When I had a green light on the Khub and TV was working I used my hot glue gun and put a bead around the Khub/Kbox where it connects to the com port to hold it in place and that cured the problem until now - must have inadvertantly knocked that loose somehow but back up now - time to dig out the glue gun again and secure the dang khub once again to the box.

[Dod]

i'm down at 10h30 pm. i did a hard reboot and no result. anyone else ?