Corotor II and 13/18v Polarity

[dmyers6]

I currently have a Pansat 2500A connected to a 10' mesh dish with a Corotor C/KU (w/Polarizer), and use a PowerTech GBox 3000 (via DiSEqC 1.2) to move the dish.

Is there any way to control the polarizer with the 13/18v H/V control on the coax cable?

I like the reception I get with the Corotor II, but my only choice for a new receiver that has skew control, is the Pansat 3500.

Thanks

[trinity13]

Originally Posted by dmyers6

Is there any way to control the polarizer with the 13/18v H/V control on the coax cable?

No (at least none that I'm aware of).

[updatelee]

your refering to the type that has two lnb's, one for H and one for V right ? best imo would to to run both those lines into a multiswitch with DC blocks on them. then you can use voltage switching and the multiswitch will do the selection for you.

if your refering to the type that has one lnb, but uses a servo to manually select polarity then I beleive its the pansat 3500 that has servo control. might be an option, they can be got fairly cheap and have blindscan.