EXTREMEVIEW Magnum 
Reply With QuoteAs long as it says boot,it should take firmware- assuming you are using the correct cable and the receiver wasn't messed up in a failed skyview conversion attempt.
Junior Member
My magnum is stuck on boot. It wont take a file or show up any thang on the tv. Help me please.
DSSRookie VIP Member
boot
As long as it says boot,it should take firmware- assuming you are using the correct cable and the receiver wasn't messed up in a failed skyview conversion attempt.
Junior Member
its the same cable that came with the box. it has been setting for about a year. it was working fine when i unhooked it and swaped to a viewsat.
DSSRookie VIP Member
loader
Don't forget you have to start the loader first,then turn the receiver on.
I had a receiver that would bounce back and forth between boot and ---- in an endless cycle,but that took new firmware.I also had to disconnect the power cable from power supply to mainboard and reconnect(power unplugged of course) to get it working again.
Junior Member
mine is loosing channels and hast to reboot a lot
DSSRookie VIP Member
lose
You are going to lose them all before long.
Junior Member
i figured a nother ecm is comming . mine acts up just before them.
Super Moderator
I am feeling very festive for the season.
If this post helped you then hit the THANKS button or donate to DSSRookie
SOME PEOPLE ARE LIKE SLINKIES - NOT REALLY GOOD FOR ANYTHING BUT THEY BRING A SMILE TO YOUR FACE WHEN PUSHED DOWN THE STAIRS.
CAPTIVEWORKS Disc
CAPTIVEWORKS Disc
CAPTIVEWORKS Disc
Posting Permissions